very different bedrock velocity using or not the ellipticity peak

This forum is dedicated to discuss all problems and suggestions related to the inversion software
Post Reply
luigiV
Posts: 33
Joined: Fri Jul 17, 2020 9:28 am

very different bedrock velocity using or not the ellipticity peak

Post by luigiV »

Hi Marc, welcome back to the forum.
I would like to submit this situation where the result of the joint inversion is very different using or not the ellipticity peak. This is evident both in the ellipticity plot and in that of the ground profiles where the bedrock speed ranges from 700m/s to 3000m/s. The ellipticity curve was obtained with HVTFA m = 8 nppm = 5. I tried to use the curve as if it were without singularity or with singularity (right side of the peak), but the result is identical.
The frequency gap between ellipticity and dispersion is approximately equal to 2 and I am aware that it is not optimal.
Can you help me understand why I get these different results?
Thank you
Luigi
Attachments
castellina.dinver
(24.34 KiB) Downloaded 8 times

Post Reply