Bug 186 :

Status: Obsolete

dinver

General information

--FATAL ERROR-

Segmentation fault Signal

2008-07-21 16:10:08.477

main,layerPainter1,layerPainter2,run_01

Current thread:

---- thread main
qtblogview.cpp:32
---- thread layerPainter1
qtblayerpainterthread.cpp:39
---- thread layerPainter2
qtblayerpainterthread.cpp:39
---- thread run_01
qtbdispersion.h:57
qtbdispersionfactory.cpp:135
qtbtargetlist.cpp:205
qtbtargetlist.cpp:189
..\moc\../src/qtbdcinversion.h:67
qtbnamodels.cpp:321
qtbinversionthread.cpp:281
qtbinversionthread.cpp:246

Developer comments (common to all duplicates if any)

Still no comments.

Systems and versions

Windows XP

  Qt                  4.3.4
  qtbtools            1.14.2 (200805162003, built key 200805181557)
  dinvercore          0.6.1 (200804251900, built key 200805181557)
  qtbguitools         1.8.2 (200805162004, built key 200805181557)
  scifigs             2.1.3 (200805162005, built key 200805181557)
  dinver              0.3.3 (200805162007, built key 200805181557)
  qtbwave             0.7.1 (200803062243, built key 200805181557)
  qtbwavegui          0.4.1 (200804251855, built key 200805181557)
  dinverdccore        1.3.4 (200805162008, built key 200805181557)
  dinverdc            1.3.2 (200804251910, built key 200805181557)

User reports and comments

186

280

2008-07-21 14:15:26

I am using Dinve (snapshot of May 2008, windows machine). In my target I set three goals: dispersion curve auto-correlation curves (5 rings) ellipticity peak (in my case 0.8 Hz with std dev of 0.05 Hz). I suspect that the introduction of ellipticity peak is the reason of my crash, because with the auto-correlation curves jointly with the dispersion curve the inversion is ok. The crash happens as soon after the run of inversion ( I began to see the misfit curve vs generated models, and then the application crash).