Geopsy Command line Param file issue

[laleh]

Hi Marc,

I have been using Geopsy hv command line to process hv files in batch mode. I made an assembled parameters file for this purpose , as you see in the example I wanted to filter my data and I have anti-triggering on, but when I run this in command line I see that the output stated the "anti-triggering on filter data = N". in general I am not sure if this params file is working effectively and applying all the preprocessing on my data. how can I make sure that data is being filtered and STA/LTA is being applied?

Thank you.
Laleh

[andrea_V]

Good afternoon!

I had the same problem with an older version of Geopsy. Are you running the last version?

[laleh]

Hi Andrea,

Thanks for your reply.

In the batch mode I'm not using the new versions, as these are old results but I wanted to make sure if the filtering was applied to them and avoid regenerating the results.

Does it work fine with the new version? is there a way that you could try to make sure if it's applying all the paramters?

Thanks

[andrea_V]

I'm sorry, with my data your parameters in geopsy 3.5.2 just do not pick any window and i don't understand why... even changing some parameters. I did not check them all though.

Good luck!

Andrea

[admin]

Hi,
When running geopsy-hv, the parameters used for processing are listed in the terminal and in the .log file. In the log file there is also a list of the time windows. Check with the graphical interface for a particular case. Are the number of time windows the same with geopsy-hv and within the GUI? Do they exactly match?
Best regards,
Marc

[laleh]

Hi Marc,

Thank you for your reply.

no they don't match, I remember you checked this previously and it's fixed in 3.6. version which I assume is not out yet. I saw your reply to my other post regarding using the git repository to get the new changes. that should work (https://www.geopsy.org/forum/viewtopic. ... aleh#p2036)

thank you,
Laleh